LCD Display Error Codes

‍

Introduction to error codes of all models of CycleBoard and some fixes to it.

‍

‍

Error codes are specific to the style of display and this guide covers all generations of displays.

‍

If there is no error code and the display turns on, but the board does not move after pushing to start, then follow the brake sensor adjustment guide.

‍

‍

Motor Errors/Hall Sensor - Unplug and plug in the motor connector inside the chassis and replace the motor if that does not resolve the issue.

‍

‍

Throttle Errors - Unplug and plug in the throttle connector at the top of the handle and replace the throttle/LCD if that does not resolve the issue.

‍

‍

Controller Error - Replace the controller.

‍

‍

Low Battery/Under Voltage - Replace the battery.

‍

‍

Communication/Receive Error - Check the throttle/LCD connector at the top of the handle as well as the throttle cable connector inside the chassis where it connects to the controller.

‍

‍

Elite/Elite Pro/Rover/Golf (2020 - )

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

Procedure - With the display on the main screen, short press the center power button several times until the lower portion of the screen shows ERR.

‍

‍

Error Codes

‍

000 - No Error

‍

006 - Low Battery Level

‍

007 - Motor Error

‍

008 - Throttle Error

‍

009 - Controller Error

‍

010 - UART Receive Error

‍

011 - UART Receive Error

‍

‍

Elite Pro/ Rover (2019)

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

Procedure - With the display on the main screen, the error code will be displayed in the top left corner of the display where the speed is normally displayed and there will be a warning symbol on the display.

‍

‍

Error Codes

‍

Error 0 - Under voltage Protection

‍

Error 1 - Overvoltage Protection

‍

Error 2 - Controller Malfunction

‍

Error 4 - Communication Fault

‍

Error 5 - Hall Sensor Malfunction (Motor)

‍

Error 6 - Throttle/Display Malfunction

‍

Error 7 - Brake Malfunction

‍

1% Battery - Throttle/Display Malfunction

‍

‍

‍

Elite (2017-2019)

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

Procedure - With the display on the main screen, short press the upper power button several times until the lower portion of the screen reads E-000.

‍

‍

Error Codes

‍

Error 1 - Motor Fault

‍

Error 2 - Turn Fault

‍

Error 3 - Controller Failure

‍

Error 4 - Power Brakes

‍

Error 5 - Under voltage Protection

‍

Error 6 - Communication Fault: Throttle isn’t receiving a signal from the motor controller

‍

Error 7 - Communication Fault: Motor controller isn’t receiving a signal from the throttle

‍

‍

‍

‍

Have more questions? Contact support@cycleboard.com