Hand Grips

‍

Guide for installing, removing or adjusting the Hand Grips on all CycleBoard models.

‍

Required Equipment

‍

• 3 mm Allen Wrench
• 5 mm Allen Wrench

‍

Recommended Equipment

‍

• Rubber Mallet (Hammer)

‍

Procedures

‍

• Loosen the Grips - Use a 3 mm Allen Wrench to loosen the screw on the collar of the handgrip and a 5 mm Allen to loosen the screw at the end of the handgrip (2-3 turns).

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

• Remove the Hand Grip - Twist the handgrip with one hand as you pull it off. If it is too hard to remove then loosen the end screw 1 revolution at a time until the handgrip can be pulled off.

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

• Install the Hand Grip - When installing the handgrip use a rubber mallet to tap it onto the hand bar to make it easier to install then tighten the 5 mm screw on the handgrip.

‍

‍

Have more questions? Contact support@cycleboard.com

‍